AnnualReport-1931 — Page 621

Administrative Reports 行政報告書 All AI Reviewed

47

Loan Works.

Paper Works Reservoir. The station which is situated near the Paper Mills Dam is a single-story building with brick walls and reinforced concrete flat roof. The building is divided into two sections by a brick wall, one section housing the electric motor and pumping equipment and the other section is a store room and sleeping accommodation for the attendant. The installation which is used to deliver from the Paper works or Aberdeen Lower Dam, either to the Aberdeen Upper Dam or to the Elliot Filters consists of an 8" Mather & Platt "Medivane" Split casing Type medium Lift Centrifugal Pump, capable of delivering 1,390 gallons of water per minute against a total head of 103 feet when running at a speed of about 1,500 revolutions per minute and is driven by a "Mather and Platt" Screen Protected Slipping Rotor Induction Motor capable of developing an output of 65 B.H.P. continuously, when running at a full load speed of 1,500 revolutions per minute, working from a 350 volts, 50 cycles, three-phase supply. The switch gear is the "Totally Enclosed Triple Pole Free handle Oil immersed combined Stator and Rotor Control Panel" type.

282. Top Water Level of Aberdeen Lower Reservoir 263.50 O.D. Top Water Level of Aberdeen Upper Reservoir 365.00 Level of ground floor of Pumping Station 201.34 Level of Engine Bed 201.84 Level of Horizontal Centre Line of Pump and Motor 203.66 Diameter of Suction Pipe 10 inches Diameter of Delivery Pipe 8

283. Item 8, Pumping Station-Aberdeen Lower Pumping Station. This work was referred to in paragraph 250 Item 8 of last year's Report. By the end of August this station was completed and the pumps and motor installed and successfully tested. The building which is situated on Island Road at the Eastern end of the Aberdeen Docks is of the reinforced concrete frame and brick panelled type. The ground floor is divided into two sections by a half wall, one section housing the electric motor and pumping equipment and the other side is an office and store room, whilst at the back there is a staff kitchen, bathroom and latrine. The upper floor is entirely devoted to staff sleeping and living accommodation. The installation which is used to increase the delivery from the Upper Aberdeen Dam to the Elliot Filter Beds is what is usually termed a "Booster". The plant consists of a 10" Mather & Platt "Lonovane" Split casing type, Low Lift Centrifugal Pump capable of delivering 2,780 gallons of water per minute against a total head of forty feet when running at a speed of about 1,000–970 revolutions per minute and is driven by a "Mather and Platt" Drip Proof Type Wound Rotor Induction Motor, capable of developing continuously an output of

Edit History

2026-05-09 08:26:00 · NVIDIA / meta/llama-4-maverick-17b-128e-instruct
Live
View comparison
AI Proofread
47 Loan Works. Paper Works Reservoir. The station which is situated near the Paper Mills Dam is a single-story building with brick walls and reinforced concrete flat roof. The building is divided into two sections by a brick wall, one section housing the electric motor and pumping equipment and the other section is a store room and sleeping accommodation for the attendant. The installation which is used to deliver from the Paper works or Aberdeen Lower Dam, either to the Aberdeen Upper Dam or to the Elliot Filters consists of an 8" Mather & Platt "Medivane" Split casing Type medium Lift Centrifugal Pump, capable of delivering 1,390 gallons of water per minute against a total head of 103 feet when running at a speed of about 1,500 revolutions per minute and is driven by a "Mather and Platt" Screen Protected Slipping Rotor Induction Motor capable of developing an output of 65 B.H.P. continuously, when running at a full load speed of 1,500 revolutions per minute, working from a 350 volts, 50 cycles, three-phase supply. The switch gear is the "Totally Enclosed Triple Pole Free handle Oil immersed combined Stator and Rotor Control Panel" type. 282. Top Water Level of Aberdeen Lower Reservoir 263.50 O.D. Top Water Level of Aberdeen Upper Reservoir 365.00 Level of ground floor of Pumping Station 201.34 Level of Engine Bed 201.84 Level of Horizontal Centre Line of Pump and Motor 203.66 Diameter of Suction Pipe 10 inches Diameter of Delivery Pipe 8 283. Item 8, Pumping Station-Aberdeen Lower Pumping Station. This work was referred to in paragraph 250 Item 8 of last year's Report. By the end of August this station was completed and the pumps and motor installed and successfully tested. The building which is situated on Island Road at the Eastern end of the Aberdeen Docks is of the reinforced concrete frame and brick panelled type. The ground floor is divided into two sections by a half wall, one section housing the electric motor and pumping equipment and the other side is an office and store room, whilst at the back there is a staff kitchen, bathroom and latrine. The upper floor is entirely devoted to staff sleeping and living accommodation. The installation which is used to increase the delivery from the Upper Aberdeen Dam to the Elliot Filter Beds is what is usually termed a "Booster". The plant consists of a 10" Mather & Platt "Lonovane" Split casing type, Low Lift Centrifugal Pump capable of delivering 2,780 gallons of water per minute against a total head of forty feet when running at a speed of about 1,000–970 revolutions per minute and is driven by a "Mather and Platt" Drip Proof Type Wound Rotor Induction Motor, capable of developing continuously an output of
Baseline (Original)
47 Loan Works. Paper Werks Reservoir. The station which is situated near the Paper Mills Dam is a single story building with brick walls and reinforced concrete flat roof. The building is divided into two sections by a brick wall, one section housing the electric motor and pumping equipment and the other section is a store room and sleeping accommodation for the attendant. The installation which is used to deliver from the Paper works or Aberdeen Lower Dam, either to the Aberdeen Upper Dam or to the Elliot Filters consists of an 8" Mather & Platt "Medivane" Split casing Type medium Lift Centrifugal Pump, capable of delivering 1,390 gallons of water per minute against a total head of 103 feet when run- ning at a speed of about 1,500 revolutions per minute and is driven by a "Mather and Platt" Screen Protected Slipting Rotor Induction Motor capable of developing an output of 65 B.H.P. continuously, when running at a full load speed of 1,500 revolu- tions per minute, working from a 350 volts, 50 cycles, three phase supply. The switch gear is the "Totally Enclosed Triple Pole Free handle Oil immersed conbined Stator and Rotor Con- trol Panel" type. 282. Top Water Level of Aberdeen Lower Reservoir Top Water Level of Aberdeen Upper Re- servoir 263.50 O.D.. 365.00 1} Level of ground floor of Pumping Station 201.34 Level of Engine Bed... 19 201.84 " Level of Horizontal Centre Line of Pump and Motor 203.66 >> Diameter of Suction Pipe.. 10 inches Diameter of Delivery Pipe 8 283. Item 8, Pumping Station-Aberdeen Lower Pumping Station. This work was referred to in paragraph 250 Item 8 of last year's Report. By the end of August this station was com- pleted and the pumps and motor installed and successfully tested. The building which is situated on Island Road at the Eastern end of the Aberdeen Docks is of the reinforced concrete frame and brick panelled type. The ground floor is divided into two sections by a half wall one section housing the electric motor and pumping equipment and the other side is an office and store room whilst at the back there is a staff kitchen, bathroom and latrine. The upper floor is entirely devoted to staff sleeping and living accommodation. The installation which is used to increase the delivery from the Upper Aberdeen Dam to the Elliot Filter Beds in what is usually termed a "Booster". The plant consists of a 10" Mather & Platt "Lonovane" Split casing type, Low Lift Centrifugal Pump capable of delivering 2,780 gallons of water per minute against a total head of forty feet when running at a speed of about 1,000—970 revolutions per minute and is driven by a "Mather and Platt" Drip Proof Type Wound Rotor In- duction Motor, capable of developing continuously an output of
2026-05-09 08:26:00 · Baseline
View content

47

Loan Works.

Paper Werks Reservoir. The station which is situated near the Paper Mills Dam is a single story building with brick walls and reinforced concrete flat roof. The building is divided into two sections by a brick wall, one section housing the electric motor and pumping equipment and the other section is a store room and sleeping accommodation for the attendant. The installation which is used to deliver from the Paper works or Aberdeen Lower Dam, either to the Aberdeen Upper Dam or to the Elliot Filters consists of an 8" Mather & Platt "Medivane" Split casing Type medium Lift Centrifugal Pump, capable of delivering 1,390 gallons of water per minute against a total head of 103 feet when run- ning at a speed of about 1,500 revolutions per minute and is driven by a "Mather and Platt" Screen Protected Slipting Rotor Induction Motor capable of developing an output of 65 B.H.P. continuously, when running at a full load speed of 1,500 revolu- tions per minute, working from a 350 volts, 50 cycles, three phase supply. The switch gear is the "Totally Enclosed Triple Pole Free handle Oil immersed conbined Stator and Rotor Con- trol Panel" type.

282. Top Water Level of Aberdeen Lower

Reservoir

Top Water Level of Aberdeen Upper Re-

servoir

263.50 O.D..

365.00

1}

Level of ground floor of Pumping Station 201.34 Level of Engine Bed...

19

201.84

"

Level of Horizontal Centre Line of Pump

and Motor

203.66

>>

Diameter of Suction Pipe..

10 inches

Diameter of Delivery Pipe

8

283. Item 8, Pumping Station-Aberdeen Lower Pumping Station. This work was referred to in paragraph 250 Item 8 of last year's Report. By the end of August this station was com- pleted and the pumps and motor installed and successfully tested. The building which is situated on Island Road at the Eastern end of the Aberdeen Docks is of the reinforced concrete frame and brick panelled type. The ground floor is divided into two sections by a half wall one section housing the electric motor and pumping equipment and the other side is an office and store room whilst at the back there is a staff kitchen, bathroom and latrine. The upper floor is entirely devoted to staff sleeping and living accommodation. The installation which is used to increase the delivery from the Upper Aberdeen Dam to the Elliot Filter Beds in what is usually termed a "Booster". The plant consists of a 10" Mather & Platt "Lonovane" Split casing type, Low Lift Centrifugal Pump capable of delivering 2,780 gallons of water per minute against a total head of forty feet when running at a speed of about 1,000—970 revolutions per minute and is driven by a "Mather and Platt" Drip Proof Type Wound Rotor In- duction Motor, capable of developing continuously an output of

Comments

Approved members can add comments, bookmarks, and private notes.

No comments yet.

Private Research Note

Private notes are available after approval.