** ASIAN INTERNA.
LANGKON-THAILAND
Sealant
Products made and displayed by W. Graham Hitchins Ltd. include water- proofing, sealing and colouring com- pounds for stone or masonry walls, floor hardening materials, expansion jointing and cement additives.
Best known of these is the Gunac process, a sealant and decorative coat- ing for concrete structures. It con- sists of resin/bitumen base coats over- laid with coloured synthetic resins and finished with a clear top coat.
W. Graham Hitchins, Ltd.. Blen- heim.
UNITED STATES
Earthmovers
Caterpillar equipment on show in- cludes the D8H. D6C, and D4D tractors, and the 955 and 977 Traxcavator power shovels.
Largest of the tractors is the D8H which is fitted with a turbocharged
لعمي
EAT
Caterpillar D8H tractor
270 flywheel h.p. diesel engine. There is a choice of transmissions: torque converter power shift ог constant mesh direct drive with oil clutch.
Power shift gives three forward and three reverse speeds up to 8 m.p.h., while direct drive gives six forward and six reverse up to 6.4 m.p.h. Track gauge is 84in. Steering is hydraulically actuated.
Caterpillar Tractor Co.. Peoria, Ill.
Tractor loader
Allis-Chalmers TL-545 tractor loader is powered by a 135 h.p. diesel, weighs 16,700 lb. and has a 14 cu. yd. standard bucket.
Allis-Chalmers TL-545 loader
Power steering and power brakes are coupled with a single lever speed and direction control. Static tipping load is 12,000 lb.
The transmission is a full power shift with two speeds forward and one reverse. With the use of a twin turbine torque converter, the trans- mission becomes, in effect, a four speed forward and a two speed
reverse.
For example, the first turbine and its output gear provide the high tor- que output (5.1:1 at full stall) neces- sary for crowding the pile and getting the load underway. The second tur- bine and its gear set provide more speed with less torque for travelling. The transition from crowd to travel is automatic.
Allis-Chalmers, Milwaukee, Wis.
Ceilings
manufacture,
In
Johns-Mansville Acousti-Shell ceiling units start as a fibre glass blanket which is then heat- moulded and compressed into shape.
The completed units are of a shell- like thickness (approximately 1/8 in.) but have good acoustical efficiency and are extremely strong and rigid.
They are lay-in units for installa- tion on the flanges of an exposed metal grid system of interlocking
tees. They are available in a choice of standard shapes and finishes: tex-
Acousti-Shell ceiling
tured vaults, fabric faced vaults, tex- tured inverted coffers, textured and fabric faced flats. John-Mansville, Street. New York.
22 East 40th
TAIWAN
Hydraulic pump
Tai Long Enterprise Co., Ltd. show an automatic hydraulic pump which uses the water hammer effect to create lift. No fuel or electric motor is needed and the pump operates for long periods without attention.
Maximum lift is 30 times the head of water above the pump inlet and maximum delivery is up to 1,000 litres per minute. Applications in- clude irrigation and domestic water supply.
Tai Long Enterprise Co., Ltd., 23 Cheng Chow Road, Taipei.
Far East Architect & Builder November, 1966
Asphalt felt
PERIL AND
PROSPERITY
THROUGH
Y TRADE COOPER
Pao Feng Industrial Co., Ltd. have pioneered the manufacture of asphalt felt and asphalt roofing in Taiwan.
Pao Feng asphalt felt
The asphalt felt is made by running a felt of vegetable fibres and cel- luloses through a molten asphalt bath, followed by squeezing and dry- ing. The roofing follows the same procedure but with the additional treatment of spraying asphalt on both sides after drying. A mica, sand or granular surface may then be applied.
Both materials are produced in rolls of 22 or 44 metres, 1 metre wide.
Pao Feng Industrial Co., Ltd., 28-1 Chungshan N. Road, Section 2. Taipei.
Air compressors
Swan models SA and WA compres- sors are air cooled single stage V-belt driven and portable. They are equip- ped with an air filter, pressure gauge, safety valve and an unloader which automatically regulates the air pres-
sure.
The crankcase is totally enclosed and dust proof and lubrication is automatic and positive. The drop
SWAN
Swan SA25 compressor
forged crankshaft is carried in two large main bearings.
Units are available from 21⁄2 to 15 h.p. with displacement from 46 to 1.470 litre min.
Tong Cheng Iron Works Co. Ltd.. 116 Shing Yee Street. Taichung.
59
Page 65Page 66