8.9
measured using Command Upconverter 2 and HPA 1 at the DISH antenna command frequency and HPA 2 at the OMNI antenna command frequency.
The antenna gain and feed losses, known from the feed used factory acceptance test and analysis will be along with the measured HPA power to calculate the EIRP. All power measurements will be made through the transmit couplers.
status and Control
8.9.1 Computer Substitution Test
The ability to substitute the spare realtime computer for
via another
patching will
demonstrated during
acceptance tests.
be
8.9.2 Orbital Operations Computer Substitution Test
9.0
9.1
9.2
site
The ability to bring the backup Orbital Operations computer up
on on-line
Computer will Operations
as
Orbital
demonstrated during site acceptance tests.
QUALITY ASSURANCE
be
well
In order to ensue that the SCF system for AsiaSat meets all
requirements, is performance
and maintainable, documented, provisions will be made in the implementation
to apply quality program
as controls
part of engineering activity. These quality assurance provisions fall into categories listed below.
Management Controls
the
The establishment of a dedicated program office with the requisite engineering and support skills will provide the basis for assuring a quality product. The overlaying of this structure with senior management support and review on
work will enhance the regular basis will
of the Program Office. A Critical Design Review will provide a basis for assuring the development of a quality product that meets the specification.
a
Design and Manufacturing Controls
The design of the system and each subsystem will be rigorously reviewed within the project team using
using the specification as the vehicle. Specification reviews will be held periodically to ensure design compliance. Careful attention will be paid to the use of proven designs and to the specification of interfaces. Quality assurance requirements consistent with commercial practices for all hardware and software developed by the Contractor or Subcontractors will adhere to the specifications. This will encompass not only design, but manufacturing and parts
28
No comments yet.
Private notes are available after approval.